Legislative Oversight

Official bill text (stored)

Plain-text extraction from Congress.gov text formats. Canonical source remains the official URL above. Full text is prioritized for bills with roll-call votes.

119 HR 4626 IH: Don’t Mess With My Home Appliances Act 
 U.S. House of Representatives 
 2025-07-23 
 text/xml 
 EN 
 Pursuant to Title 17 Section 105 of the United States Code, this file is not subject to copyright protection and is in the public domain. 
 
 
 
 I 119th CONGRESS 1st Session H. R. 4626 IN THE HOUSE OF REPRESENTATIVES July 23, 2025 Mr. Allen introduced the following bill; which was referred to the Committee on Energy and Commerce A BILL To amend the Energy Policy and Conservation Act to prohibit the Secretary of Energy from prescribing any new or amended energy conservation standard for a product that is not technologically feasible and economically justified, and for other purposes. 
 1. Short title This Act may be cited as the Don’t Mess With My Home Appliances Act . 2. Prescribing new or amended energy conservation standards (a) Amendment of standards (1) In general Section 325(m)(1) of the Energy Policy and Conservation Act ( 42 U.S.C. 6295(m)(1) ) is amended to read as follows: 
 
 (1) In general The Secretary may, for any product, publish a notice of proposed rulemaking including new proposed standards for such product based on the criteria established under subsection (o) and the procedures established under subsection (p). . (2) Amendment of standard Section 325(m)(3) of the Energy Policy and Conservation Act ( 42 U.S.C. 6295(m)(3) ) is amended to read as follows: 
 
 (3) Amendment of standard Not later than 2 years after a notice is issued under paragraph (1), the Secretary shall publish a final rule amending the standard for the product. . (b) Petition for amended standard Section 325(n) of the Energy Policy and Conservation Act ( 42 U.S.C. 6295(n) ) is amended— 
 (1) in the subsection heading, by striking an amended standard and inserting amendment or revocation of standard ; (2) in paragraph (1), by inserting or revoked after should be amended ; 
 (3) by amending paragraph (2) to read as follows: (2) The Secretary shall grant a petition to determine if energy conservation standards for a covered product should be amended or revoked if the Secretary finds that such petition contains evidence, assuming no other evidence were considered, that such standards— 
 (A) result in additional costs to consumers; (B) do not result in significant conservation of energy or water; 
 (C) are not technologically feasible; and (D) result in such covered product not being commercially available in the United States to all consumers. ; and 
 (4) in paragraph (4)— (A) by striking New or amended standards. and inserting New, amended, or revoked standards. ; 
 (B) by redesignating subparagraphs (A) and (B) as clauses (i) and (ii), respectively (and by conforming the margins accordingly); (C) by striking Not later than 3 years and inserting the following: 
 
 (A) Not later than 3 years ; and (D) by adding at the end the following: 
 
 (B) Not later than 180 days after the date of granting a petition to revoke standards, the Secretary shall publish in the Federal Register— (i) a final rule revoking the standards; or 
 (ii) a determination that it is not necessary to revoke the standards. (C) The grant of a petition by the Secretary under this subsection creates no presumption with respect to the Secretary’s determination of any of the criteria in a rulemaking under this section. 
 (D) Standards that have been revoked pursuant to subparagraph (B) shall be considered to be in effect for purposes of section 327. . (c) Criteria Paragraphs (2) and (3) of section 325(o) of the Energy Policy and Conservation Act ( 42 U.S.C. 6295(o) ) are amended to read as follows: 
 
 (2) Requirements 
 (A) Design Any new or amended energy conservation standard prescribed by the Secretary under this section for any type (or class) of covered product shall be designed to achieve the maximum improvement in energy efficiency, or, in the case of showerheads, faucets, water closets, or urinals, water efficiency, which the Secretary determines is technologically feasible and economically justified. (B) Test procedures The Secretary may not prescribe a new or amended energy conservation standard under this section for a type (or class) of covered product if a test procedure has not been prescribed pursuant to section 323 with respect to that type (or class) of product. 
 (C) Significant conservation The Secretary may not prescribe a new or amended energy conservation standard under this section for a type (or class) of covered product if the Secretary determines that the establishment and imposition of such energy conservation standard will not result in significant conservation of— (i) energy; or 
 (ii) in the case of showerheads, faucets, water closets, or urinals, water. (D) Technologically feasible and economically justified The Secretary may not prescribe a new or amended energy conservation standard under this section for a type (or class) of covered product unless the Secretary determines that the establishment and imposition of such energy conservation standard is technologically feasible and economically justified. 
 (E) Disclosure The Secretary may not prescribe a new or amended energy conservation standard under this section for a type (or class) of covered product unless the Secretary, not later than the date on which the standard is prescribed, publicly discloses each meeting held by the Secretary, during the 5-year period preceding such date, with any entity that— (i) has ties to the People’s Republic of China or the Chinese Communist Party; 
 (ii) has produced studies regarding, or advocated for, regulations or policy to limit, restrict, or ban the use of any type of energy; and (iii) has applied for or received Federal funds. 
 (3) Factors for determination 
 (A) Economic analysis Prior to prescribing any new or amended energy conservation standard under this section for any type (or class) of covered product, the Secretary shall conduct a quantitative economic impact analysis of imposition of the energy conservation standard that determines the predicted— (i) effects of imposition of the energy conservation standard on costs and monetary benefits to consumers of the products subject to such energy conservation standard, including— 
 (I) costs to low-income households; and (II) variations in costs to consumers based on differences in regions, including rural populations, cost of living comparisons, and climatic differences; 
 (ii) effects of imposition of the energy conservation standard on employment; and (iii) lifecycle costs for the covered product, including costs associated with the purchase, installation, maintenance, disposal, and replacement of the covered product. 
 (B) Prohibition on additional costs to the consumer The Secretary may not determine that imposition of an energy conservation standard is economically justified unless the Secretary, based on an economic analysis under subparagraph (A), determines that— (i) imposition of such energy conservation standard is not likely to result in additional net costs to the consumer, including any increase in net costs associated with the purchase, installation, maintenance, disposal, and replacement of the covered product; and 
 (ii) the monetary value of the energy savings and, as applicable, water savings, that the consumer will receive as a result of such energy conservation standard during the first 3 years after purchasing and installing a covered product complying with such energy conservation standard, as calculated under the applicable test procedure, will be greater than any increased costs to the consumer of the covered product due to imposition of such energy conservation standard, including increased costs associated with the purchase, installation, maintenance, disposal, and replacement of the covered product. (C) Required energy or water savings The Secretary may not determine that imposition of an energy conservation standard is economically justified unless the Secretary determines that compliance with such energy conservation standard will result in— 
 (i) a reduction of at least 0.3 quads of site energy over 30 years; or (ii) at least a 10 percent reduction in energy or water use of the covered product. 
 (D) Criteria related to performance The Secretary may not determine that imposition of an energy conservation standard is economically justified unless the Secretary determines that imposition of such energy conservation standard will not result in any lessening of the utility or the performance of the applicable covered product, taking into consideration the effects of such energy conservation standard on— (i) the compatibility of the covered product with existing systems; 
 (ii) the life span of the covered product; (iii) the operating conditions of the covered product; 
 (iv) the duty cycle, charging time, and run time of the covered product, as applicable; (v) the maintenance requirements of the covered product; and 
 (vi) the replacement and disposal requirements for the covered product. (E) Criteria related to market competition and price discrimination The Secretary may not determine that imposition of an energy conservation standard is economically justified unless the Secretary determines that imposition of the energy conservation standard is not likely to result in— 
 (i) any lessening of market competition; or (ii) price discrimination. 
 (F) Technological innovation The Secretary may not determine that imposition of an energy conservation standard is economically justified unless the Secretary determines that imposition of such energy conservation standard is not likely to result in the unavailability in the United States of a type (or class) of products based on what type of fuel the product consumes. (G) Other considerations In determining whether imposition of an energy conservation standard is economically justified, the Secretary— 
 (i) shall prioritize the interests of consumers; (ii) may not consider estimates of the social costs or social benefits associated with incremental greenhouse gas emissions; and 
 (iii) shall consider— (I) the economic impact of the standard on the manufacturers and on the consumers of the products subject to such standard; 
 (II) the savings in operating costs, including consumer fuel costs, throughout the estimated average life of the covered product in the type (or class) compared to any increase in the price of, or in the initial charges for, or maintenance expenses of, the covered products which are likely to result from the imposition of the standard; (III) the total projected amount of energy, or as applicable, water, savings likely to result directly from the imposition of the standard; 
 (IV) the need for national energy and water conservation; and (V) other factors the Secretary considers relevant. 
 (H) Regulatory review 
 (i) Evaluation Not later than 2 years after the issuance of any final rule prescribing a new or amended energy conservation standard under this section for any type (or class) of covered product, the Secretary shall evaluate the rule to determine whether such energy conservation standard is technologically feasible and economically justified and whether the regulatory impact analysis for such rule remains accurate. (ii) Effect Notwithstanding any other provision of this part, if the Secretary determines, based on an evaluation under clause (i), that an energy conservation standard is not technologically feasible or economically justified— 
 (I) the Secretary shall publish such determination and such energy conservation standard shall have no force or effect (except that such energy conservation standard shall be considered to be in effect for purposes of section 327); and (II) the Secretary may publish a final rule amending the energy conservation standard for the type (or class) of covered product to be technologically feasible and economically justified in accordance with this subsection, which amendment shall apply to such a product that is manufactured after the date that is 2 years after publication of such final rule. . 
 (d) Conforming amendments 
 (1) Regional standards Section 325(o)(6)(D)(i)(II) of the Energy Policy and Conservation Act ( 42 U.S.C. 6295(o)(6)(D)(i)(II) ) is amended by striking this paragraph and inserting this subsection . (2) Procedure for prescribing new or amended standards Section 325(p)(2)(A) of the Energy Policy and Conservation Act ( 42 U.S.C. 6295(p)(2)(A) ) is amended by striking taking into account those factors which the Secretary must consider under subsection (o)(2) and inserting as determined in accordance with subsection (o) . 
 (3) Energy conservation standards for high-Intensity discharge lamps, distribution transformers, and small electric motors Section 346 of the Energy Policy and Conservation Act ( 42 U.S.C. 6317 ) is amended by striking subsection (c). 3. Distribution transformers Section 346 of the Energy Policy and Conservation Act ( 42 U.S.C. 6317 ) is amended by adding at the end the following: 
 
 (g) No new or revised standards for distribution transformers 
 (1) In general Beginning on the date of enactment of this subsection, the Secretary may not prescribe any new or amended energy conservation standard under part B or this part for distribution transformers, including those distribution transformers for which the Secretary prescribed testing requirements under paragraph (1) and low-voltage dry-type distribution transformers. (2) Effect on existing standards Paragraph (1) does not affect any energy conservation standards prescribed under part B or this part before the date of enactment of this subsection. .

Plain-English summary

Confidence: high · Complexity: complex · Model: grok-4.5

Related issues

• Energy & Climate
• Inflation & Cost of Living
• Regulation & Agency Oversight

How a vote maps to positions

Impartial mapping: which issue position a Yea vs Nay advances. When a bill has multiple floor votes, each roll can have its own mapping. Bill-level entries (no roll listed) apply as a default when a roll has no specific map. Used for legislator alignment.

Official citations

• Congress.gov

Member votes on this bill